:  May 13, 2004



  : It is imperative that before any work is undertaken on the SRS system, the appropriate information is read thoroughly.

  : Always disconnect both battery cables before beginning work on the SRS system. Disconnect the ground cable first. Never reverse connect the battery.

:
  If the restraints control module (RCM) is to be replaced then T4 must be connected and the correct procedures adhered to, prior to battery disconnection.

:
  If the SRS component is to be replaced, the bar code of the new unit must be recorded.

. Disconnect the battery ground cable.

. Make the SRS system safe.

. Remove the floor console.

.
  : Make sure the wiring harness is protected when cutting the carpet.

Remove the restraints control module (RCM).
  Cut the carpet for access.
  Disconnect the 2 electrical connectors.
  Remove the 3 Torx screws.




. Install the RCM.
  Tighten the Torx screws to 10 Nm (7 lb.ft).
  Connect the electrical connectors.
  Position the carpet.

. Install the floor console.

. Initiate a new RCM using T4.